Wednesday 3 September 2014

Water Filtration Plant

 

During our time in Belgium we increasing found it difficult to find water without going into a marina which is not always practical when often they are set up for smaller cruisers.

I did some research and found it really wasn’t that difficult to make potable water from river of canal water although its not a cheap solution to the problem.

Since being in France we have found free water at very occasional places but all to often the systems on moorings along with the electrics are broken and disabled.

I have saved this blog post until the first time I have used the system and survived.

The system comprises in my case 7 stages of filtration and a submersible 240v water pump.

image002
Adapted to Hozelock fittings

The pump is inside a large washable 100 micron filter bag providing the 1st stage of filtration.

The next 4 stages are 10” filter housings with reducing filter size, 50, 20, 5, 1 micron. 1 micron is 1/1000th of a mm

image001
My assistant demonstrates Smile

This bank of filters were pretty unstable relaying on just the copper fittings to hold it together so to stabilise it and toughen it up I fitted it to some 18mm ply. The problem with this is each filter has 4 screw fixings and 1 pressure release valve (the red button on top).  All of these holes needed to be transferred accurately to the ply.

image003
Masking tape template

image005
Transferred to the ply and drilled

This is what the system looks like in operation. Obviously the pump is under the water at this stage.

P1020382
UV filter is the black bit

The next stage of filtration is UV light. Read about it here. That’s how it works!  The model I chose is a 72w unit capable of a flow rate of 6000l and hour. This UV light sterilizer has a unique design which turbulates the water through a helix design, so the water does not just run through the UV but spins inside allowing the UV more exposure before the water comes back out from the outlet.  This combined with a 500l/h flow control valve I have in the system the water has maximum exposure to the UV light.

In the photo the water enters the filters through the hose on the left and exits to the tank on the right.

Once the water enters the tank its filtered to 1 micron and been exposed to massive UV radiation so is clear and sterile.  The bulk of water used is for domestic use of course but the danger is Legionella especially in the fine spry of a shower.  At this level of filtration we should be safe but an extra filter level is on the exit from the storage tank.  This is 0.5 of a micron activated carbon filter and will remove heavy metals.

The final filter is for the drinking water and was already installed on the boat.  Its a

Seagull_IV_X_1F__4db01685888af
Seagull IV

I have a TDS (Total Dissolved Solids) meter.  A recent sample of marina tap water was 240 p/p/m the water out of our drinking water tap today is 160 p/p/m

Yesterday I used it for the first time.  Obviously a quick look at the source water to see it is acceptable.  My test is would I swim in it and with Google Earth check to see you are not close down stream to a sewage farm or factory and their outfall pipe.  Not that this should be a problem but why do it if 5 miles downstream there is nothing?

I filled up with about 1500l of water which took just over 3 hours.  By the time it was done it was dark.  The UV filter has viewing windows to see the bulbs are working.

P1020385

Last night I drank 2 pints of water. I’m pleased to say having drunk another couple during today I have no Delhi Belly.

The whole system is connected by Hozelock fittings so it can be easily broken down into smaller parts for storage.

The total cost of the system including the Seagull which was already here is about £650.00

Now apart from Diesel we can live completely off grid.  If it’s sunny we can go up to 3 days on solar without running the engine to charge the batteries.  Even then with propulsion which also makes electricity, hot water and heat the radiators as we go along we only use about 50L a week when we are on the move.

8 comments:

  1. This looks very user (and builder) friendly! Thank you for posting in such detail. How often will you have to change the filters and are they easily obtainable?

    ReplyDelete
  2. The filters are very easy to get mail order a small stock is what I've done.

    As for changing them I really don't know yet. I would suspect maybe 2-3 times a year if we used it full time, and of course depending on the clarity of the source water.

    ReplyDelete
  3. Hi,

    can you tell me exactly what UV filter you used?

    Kind regards,

    James

    ReplyDelete
    Replies
    1. Yes James

      http://www.amazon.co.uk/gp/product/B003SE4WOA?psc=1&redirect=true&ref_=oh_aui_detailpage_o01_s00

      Delete
  4. Hi, This looks like a great piece of kit. Are you running water through the UV filter before the filter housings? Is there any benefot to this over using the UV filter as the last stage?

    Thanks.
    James

    ReplyDelete
    Replies
    1. The UV filter is at the end of the physical filtration part. I'm not sure if it would make a difference to the the effectecness of the UV but in my mind it has to be better to sterilise clear water not cloudy water

      I have produced probably 10 or so of these systems and nonoone to date has become ill when used as directed

      Delete
  5. Hi, Thanks for the quick reply. That makes perfect sense. I couldn't work out from the picture if it was first or last in the process. I don't suppose you recall where you purchased the brass hozelock connectors for the filter housing? I don't seem to be able to find anything similar anywhere.

    Thanks
    James.

    ReplyDelete
    Replies
    1. Just look on ebay for best price. But I know garden centres a B%Q generally have them.

      Delete